IP 1/2 not working with FW 1.4

SQ SQ General Discussions
1

So I upgraded to Firmware V 1.4 this evening and IP 1/2 which I have set to be a stereo channel “stopped working”.
I have this channel set as Stereo coming from Channels 1+2 on our second DX168 - its the keyboard, so is pretty crucial to the worship service.
The rest of the channels worked fine.

So - temp plugged the kbd into another mono channel to get thru the service and then did some investigation.

I can levels on the meter on channel 1+2 but cannot hear anything on PFL.
If I patch those inputs on the DX168 onto another stereo pair (e.g. 39/40), it works fine.
So it seems to be something odd with Channel 1+2.

I also tried switching Channel 1+2 back to mono channels without success.

I can see no difference between the 1+2 & 39+40 on the Pre-Amp screens.

Should I raise a ticket for this?

Btw - one of the reasons I upgraded is because the Mixpad updated (Android Tablet) so wouldn’t work with 1.3.2

Thanks - John

I have a workaround for the moment, but looks like there

2

I have had a simulair issue with input 2. The signalflow stopt after the gate.
When i recalled another scene input 2 was working, recalling the previous, it was dead again.
I solved this by recalling the “good scene” and save it “over the bad one” then did some adjustments regarding the scene settings fit again.

3

Hi Both,

Please do send in a ticket for this so that we can look at the cause in more detail.

Thanks!

Alex

4

Support ticket #NQK-528-42391 raised.