QU to SQ via SLink doesn't work properly

SQ SQ Troubleshooting
1

Hi,
Last weekend I had tried to link my SQ6 (at FOH) whith an QU16 on stage for monitor.
I could send my SQ Main mix to ST3 on QU to feed my PA but QU didn’t send inputs to SQ properly (wasn’t 1 to 1 channel).
I think QU was sending mixes, not individual channels.
Finally I didn’t have enough time to search anymore so I used my stagebox.

Both mixers was with the last firmware :
1.4.1 for SQ and 1.95 for QU.

QU and SQ was sets like the Allen & Heahh YouTube tutorial (click,…).

Any idea?

2

Hi
i think all u need is in these sheets

F49821A7-4E12-424D-9495-39B1FE5E6E65.jpeg
F49821A7-4E12-424D-9495-39B1FE5E6E65.jpeg936×1344 117 KB

2D440334-0D09-424A-900A-2B4DAF8C2F12.jpeg
2D440334-0D09-424A-900A-2B4DAF8C2F12.jpeg918×906 61.8 KB

3

Hi Fab
thanks I had already looked this document but… I think I must have misunderstood that.

To be clear and sure I understand correctly now :

  • QU I/O dSnake out page provide only settings for mix out
  • QU direct output are set only in the monitor page
  • to feed SQ inputs I have to set my inputs source from SLink starting from 21.

I think my mistake it was I didn’t set correctly the inputs patch…

Thanks :wink:

4

That’s it. Your input1 from qu(direct out via monitor) corresponds to slink 21. So We just have to patch slink21 to input 1 in the sq.