Hey All,
Is there a way to assign an aux send as being post fader. As far as I can tell there are only options to select the send point pre-fader but not one for post.
I’m asking this to run aux-fed subs, yes I know there are ways to run it without using an aux, but it would be really nice to have a post-fade aux. Maybe I’m just missing an option somewhere?
Cheers,
Scott
Scott… check page 21 in manual:
Hold down the Pre/Post key and press channel
Sel keys to toggle each source pre or post fader.
Current PRE status is displayed on the lower part
of the channel strip LCDs.
T112, iDR48 w/M-DANTE, PL10, MixPad, Editor
GLD-80 w/M-DANTE, GLD-AR2412, GLD-AR84 (2)
MacBook Pro, Mac Mini
Lion/Logic Pro/PT10
All latest versions/firmware
If it doesn’t say “PRE”, it’s post.
Chris
Thanks guys!
I must have been looking in the wrong place.
Cheers,
Scott