Yesterday had an issue with my t112 and idr32 - i switched from one channel (cd Input on the surface) to the other and the gain of the new selected Channel Jumper 15db higher then it was before. You can imagine what it sounded like…
Never happened before.
May this be an issue with 1.51 or an Hardware Problem?
hello
I must admit you scared me uot from upgrading firmware to 1.51.
Did it happen again ever ?
best regards
Przemko
Hi,
Did 5 shows with 1.51 and no problems so far ( not when upgrading and when mixing )
I think that a lot of the problems relate to " lost connection " of some sort. Maybe keep an eye on the trafic ligts on the status screen. Orange and red lights can cause troubles
Lieven
T112/IDR48
Disclaimer: I disclaim everything. The contents of this message might be totally inaccurate, inappropriate, misguided, or otherwise perverse - except for my name (hopefully I got that right).
Hi Albin
can you please explain in more detail what you mean by:
‘i switched from one channel (cd Input on the surface) to the other and the gain of the new selected Channel Jumper 15db higher’
Was it two mono channels you were using?
when did the jump in level happen? was it when you pressed the SEL key of the other channel? or did you change any Pre-amp setting??
Do you remember if you had rebooted the desk before this problem occured?
I Will try and replicate your issue here at A&H
Best Regards
Sam A&H