User "Basic" Issues

HI all,

i run a Qu16 in a live Club. From mix 9/10 i feed the bar area upstairs. A PC plays bar music on ST1. This is meant to play in both places during non- live opening hours, the barman needs to set the volumes to his Needs himself.

When i log into the Basic user, the desk loads the scene i created and all is good… BUT: the desk starts with LR selectd, not in MIX 9/10 layer and the Basic user seems not to be allowed to change the selection… can i change this behaviour so that the desk starts in layer 9/10?
Is this because i saved the scene when the selected Output was LR not 9/10?

Thanks Markus

Don’t know, but you could use alt-out, or a split feed and just have a control on an amp upstairs?

don’t think you can save the scene to recall on any particular layer, you might be best using the custom layer if you want restricted access

thanks for your replies- i will go and check it out…